How to Calculate the Tensile Coefficient of Stainless Steel
In fact, many times we are not concerned about the stretch of the tensile factor, in fact, this approach is not correct, why the concept of stretching coefficient, it is certainly the value of our value, but we did not pay attention to To. Here we are by the small pieces of the Central and South Africa to tell you about the stretch of our tensile modulus in the end is how the calculation. Calculate the drawing coefficient of the general formula m = dn / d0 where m total = m1m2 ... mn where dn for the drawing of the final diameter, d0 refers to the diameter of the blank. M1, m2, mn worthy of our deep drawing of the coefficient. Here we would like to remind you that the selection of each drawing is also selected by the table, such as stainless steel (0Cr18Ni9Ti) the first drawing coefficient is only the lowest 0.52 ~ 0.55, after the deepening coefficient of the lowest 0.78 ~ 0.81. Here we want to remind you that we calculate the depth of each procedure, according to the actual situation can choose different formulas. Now with the rapid development of our deep drawing process, trendy drawing technology and equipment available to further reduce our tensile modulus.
Previous article：没有了!
Next article：Selection of drawing parts for automobile